World of Warcraft Horde Inn Scratch Built 1:64
Scratch Built in approximately Model railroad “S” scale (American Flyer) or 1:64 so it would in fact be great for table top gaming, or a train layout ! Made from paper, cardboard, glue, and paint.
Lighting purchased thru:
This is just a test of the lighting that arrived today.
I just couldn’t wait to share.
The focus of test was the brown area directly below uppermost red roof area. There are many exposed areas seen in this vid that will be eventually be closed in by roof pieces.
Here’s the result.
Note there will be another set of lights in the “Lava Bay” above door.
Final coat of texture on roof beams.
Flagstone floor laid out on thick corrugated cardboard. Edge has been cut and top layer of cardboard removed for “Lave Trough”.
Stones have been cut to bottom layer of cardboard but not cut through.
Top layers of cardboard and corrugation have been removed leaving just the stones.
1st Layer of the “texture” (50% water 50% white glue mix over torn up pieces of napkins). I applied this with an old blunt (short bristle) paint brush. Hopefully 1 coat will due. We’ll see after it dries.
Well, I was not happy with the window frames.
To me they looked too “two dimensional” so I took them and the door frames off and gave them a texture.
50% water to 50% white glue using torn up napkins do the trick.
Here is a door frame before texture. The window frames looked the same.
Here are two window frames where I tested colors after texture dried. The gray (on the right) just seemed too flat so I went with the silver on the left; which is actually nail polish.
Redone windows and doors.
Also, I’ve been asked how I weather: Just use very little paint of a light color over dried dark base as shown.